419-10 Multifunction Electronic Modules	2013 - 2014 Fusion
General Procedures	Procedure revision date: 06/27/2013

Transport Mode Deactivation

NOTE: During vehicle build, some vehicle modules are set in factory mode including the IPC and the BCM . While in the factory mode, the IPC displays FACTORY MODE CONTACT DEALER in the message center. If the vehicle is set in factory mode, the system does not automatically revert to another mode and must be manually set to either the transport or normal operation mode. When the vehicle build is complete, the vehicle is set to transport mode. While in transport mode, the IPC displays TRANSPORT MODE CONTACT DEALER in the message center. Transport mode reduces the drain on the battery during longer periods where the vehicle is not used. Various systems may be altered or are disabled when in the transport mode. The vehicle automatically reverts to normal operation mode after being driven 120 km (75 mi).

WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.
Place the ignition in the OFF position.

Verify the battery is fully charged.
Refer to: Battery (414-01 Battery, Mounting and Cables, Diagnosis and Testing).

Place the ignition in the ON position.

NOTE: Steps 4 and 5 must be carried out within 10 seconds.
Press and release the brake pedal 5 times.

NOTE: The IPC message center will indicate NORMAL MODE when the procedure has been successfully completed.
Press and release the hazard switch 2 times.

Start the engine.

Place the ignition in the OFF position.

Verify the RKE works correctly.